Your shopping cart is empty!
Pipeclamp
A 90 deg tee connection between two tubes. Typical use is on straight and level guardrail to connect..
A 90 deg tee connection between two tubes.Typical use is on straight and level
guardrail to conn..
A 90 deg corner joint with the vertical passing through the SES pipeclamp fitting.
Typical use is..
A 90 deg joint between a vertical and two horizontals. Typical use on straight and level guardrail t..
A 90 deg elbow. Typical use is to connect the end vertical to the top rail in straight and level gua..
A three way enclosed 90 deg corner joint. Typical use is on straight and level guardrail at a 90 cor..
With four countersunk holes, this fitting is ideal as a flange to terminate handrail to a wall or ot..
A structural base plate for all aspects of vertical post support. This fitting when used as a base p..
A plastic stop end for use in the end of tubes. This stop end can be used in either medium or heavy ..
A ground socket cast into concrete which is flush to the finished ground level.
The upright is he..
Inline tee add on tee. Used for making additions to upgrading or modifying an existing structure wit..
Female section of a two part gate hinge.Used in conjunction with SES pipeclamp fitting reference 140..
Male section of a two part gate hinge. Used in conjunction with SES pipeclamp fitting reference 138...
Wall mounting bracket for handrails. Can also be used to the back structures to wall or to hold kick..
Structural offset side palm base fixing guardrailing to walls,steps,ramps,etc. The tube is unable to..
This fitting is designed for palm fixing guardrailing and balustrading to walls, parapets,steps and ..
Structural flush side palm base fixing guardrailing to wall, steps or ramps etc. The flush design en..
Shown priced and sold as a single fitting but normally used in pairs to create angles between 85 deg..
An inline external tube connector for joining two tubes of the same diameter. This fitting is not re..
An inline internal tube connector for jointing two tubes of the same diameter. This fitting can only..
A four way cross that enables the vertical to pass through the centre of the fitting with the four h..
Complete double swivel with the swivel connectors at 180 deg to each other. Each swivel has a travel..
Complete locating swivel. Swivel has a travel of approximately 86 deg from the vertical in each dire..
Double location weldmesh panel clip. This slotted design of the panel clip enables adjustment in the..
Double location weldmesh panel clip. The slotted design of the panel clip enables adjustment in the
..
Complete single swivel. The swivel has a travel of approximately 85 deg from the horizontal&nb..
Three way tee used to join three tubes at 90 deg to each other with the vertical passing through the..
Chain hook is used to locatechains across openings. The fitting is not ideal for permanent chain loc..
Hexagonal key. The Allen key is the only tool required to tighten up an SES pipeclamp fitting.
Th..
Showing 1 to 29 of 29 (1 Pages)
© Copyright SES Pipeline 2024, All Rights Reserved